Panasonic WV-CW500S/G - Manual (Page 13)

13
When "AWC" is selected, follow the steps below to adjust the white balance.
Step 1
Set "WHITE BAL" to "AWC" and press the left button to change to "AWC → PUSH SW".
Step 2
Press the setting button and adjust the white balance.
"PUSH SW" is reversely highlighted during adjustment. When the reversely highlighted display is restored, the white balance adjust-
ment is completed.
Step 3
Press the right button to select "AWC".
Refer to the following for fine adjustment of the white balance.
Note:
• The adjustment of the color temperature ranges from approx. 2 000 K to 10 000 K. If the correct range is out of this adjustment
range or lighting directed to a subject is too dark, the white balance may not completely adjusted. In such a case, "PUSH SW"
stays reversely highlighted.
Manual fine adjustment of white balance
The white balance is manually fine adjusted after white balance automatically adjustment in the automatic color temperature tracking
mode (ATW1, ATW2) or automatic white balance control mode (AWC).
Follow the procedure below.
Step 1
Set "WHITE BAL" to "ATW1", "ATW2" or "AWC" and press the setting button.
→ The fine adjustment screen appears.
Step 2
Move the cursor to "R" and "B" and use the right or left button to fine adjust the level for each.
When the level indicator moves in the "+" direction, the color becomes deeper, and when the level indicator moves in the "–" direc-
tion, the color becomes lighter.
**CAMERA SETUP**
SCENE1
ALC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL AWC PUSH SW
DNR HIGH
BW MODE AUTO1
i-VMD
RET TOP END
"CAMERA SETUP" screen
**CAMERA SETUP**
SCENE1
ALC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
BW MODE AUTO1
i-VMD
RET TOP END
Fine adjustment screen "CAMERA SETUP" screen
**ATW1**(1)
R ...|... 0
- +
B ...|... 0
- +
RET TOP END