Panasonic WV-CP504E - Manual (Page 16)

16
9. i-VMD setting [i-VMD]
The intelligent motion detection function allows the camera to detect motion and appearance/disappearance of an object or
interference with the camera. Detection of motion and appearance/disappearance of an object or interference with the camera
can be announced by issuing an alarm signal or displaying a frame on the screen.
Important:
• The following circumstances may result in detection failure or false detection: Adjusting the detection area and sensitivity
may cause detection failure.
• Not enough difference in brightness between the background and the moving photographic subject, or significant
changes in brightness
• Dirt or water drops on the lens
• Insufficient brightness, for example, when shooting at night
• The subject is moving straight at the camera
• The subject is moving too fast or too slow
• The subject is too small or too large
• There are too many moving objects
• Light reflected through a window or from a road surface
• The camera is shaking
• Entry of outside light, such as sunlight or the headlights of a car
• Flickering fluorescent light
• Interference detection may fail in the following cases:
• The lens is partially covered or covered with a transparent item
• The photographic subjects before and after changing the camera direction are similar
• Detection is disabled for approx. 1 minute after turning on the power, after completing settings in the SETUP menu, or after
changing the camera view angle.
Perform the settings relating to the motion detection
Perform the settings relating to the motion detection as follows. It is possible to detect only objects that moves to the direction
specified in advance or objects that keeps on moving for a certain duration.
Follow the procedure below. Up to 4 motions can be simultaneously detected.
Step 1
Move the cursor to "i-VMD" and press the setting button.
→ The "i-VMD SETUP" screen appears.
Step 2
Move the cursor to "MOTION DET" and press the setting button.
→ The "MOTION DET" screen appears.
Step 3
The setting of the motion detection mode is performed. This unit has 3 types of motion deteciton modes.
"SENSITIVITY" screen
**SENSITIVITY**(1)
SENSITIVITY LOW
MIN SIZE OFF
RET TOP END
**CAMERA SETUP**
SCENE1
ALC/ELC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
BW MODE AUTO1
i-VMD
RET TOP END
"i-VMD SETUP" screen "CAMERA SETUP" screen
**i-VMD SETUP**(1)
MOTION DET
OBJECT DET OFF
SCENE CHANGE OFF
INDICATOR OFF
ALARM CONT
RET TOP END
"MOTION DET" screen
**MOTION DET**(1)
MOTION OFF
LOITERING OFF
DIRECTION OFF
AREA ALL
SENSITIVITY
RET TOP END