Connecting speakers, For the dg100-212a, For the dg80-210a/dg80-112a – Yamaha DG100-212A EU User Manual

Page 8: For the dg130ha, Total impedance, Dg100, Dg80, Dg130h

Advertising
background image

8

For the DG100-212A

The amplifier’s internal speaker (4

) is connected to the speaker jack.

If it is necessary, you can disconnect the internal speaker and connect

an external speaker to the speaker jack.

When an external speaker is used, make sure the speaker(s) meets the

following requirements.

• A power rating of at least 100 W, impedance of 4 – 8

.

For the DG80-210A/DG80-112A

The amp’s internal speaker (8

) is connected to the SPEAKER 1 jack.

The SPEAKER 2 (EXT) jack can be used to add an external speaker(s).

Also, if necessary, you can disconnect the internal speaker to connect 2

external speakers directly to the amp. The two speaker jacks are con-

nected in parallel. When external speakers are used, make sure the

speakers meet the following requirements.

When one speaker jack is used.

• A power rating of at least 100 W, impedance of 4 – 16

.

• The total impedance for the speakers in a circuit must not be less

than 4

.

When both speaker jacks are used.

• Speakers connected to each jack must have a power rating of at

least 100 W, and impedance of 8 – 16

.

• The total impedance for the speakers in a circuit must not be less

than 4

.

For the DG130HA

The amp is equipped with two speaker jacks. The two speaker jacks are

connected in parallel. Make sure the speakers meet the following re-

quirements.

When one speaker jack is used.

• Power rating of at least 130 W, impedance of 4 – 16

.

• The total impedance for the speakers in a circuit must not be less

than 4

.

When both speaker jacks are used.

• Speakers connected to each jack must have a power rating of at

least 100 W, and impedance of 8 – 16

.

• The total impedance for the speakers in a circuit must not be less

than 4

.

Connecting Speakers

Before connecting speakers to the speaker jack(s) check the power rating and impedance of the speaker and make sure

they meet or are within the requirements recommended for the equipment.

Total Impedance

If two or more speakers are to be connected, you must take into

consideration the total impedance of the speakers.

Speakers normally have an impedance of 4, 8 or 16

. When two

or more speakers are used together, the total impedance will

change according to the manner in which the speakers are con-

nected.

Connecting in a series

The total impedance equals the impedance of the 1

st

speaker +

2

nd

speaker + 3

rd

speaker + …

When three speakers are connected in a series, as shown be-

low, the total impedance will be 24

.

Connecting in a parallel series

The total impedance =

When three speakers are connected in a parallel series, as shown

below, the total impedance will be about 2.7

.

For the DG80-210A/DG80-112A

The two speaker jacks are connected in a parallel circuit inter-

nally therefore, adding a 4

external speaker to the 8

internal

speaker results in a total impedance of 2

. In order to maintain

a minimum impedance of 4

, an 8

speaker or greater must be

used as an external speaker.

External Speaker

Greater that 8

Internal Speaker 8

DG100-

212A

/DG80-

210A

/DG80-

112A

/DG130H

A

Advertising
This manual is related to the following products: