American Car Craft Challenger Water Tank Cover w_Cap Polished 5.7L_SRT8 6.1L_6.4L 2011-2014 User Manual
Page 2
1. Remove the water tank pressure cap. Remove the factory bolt just above and to the right side of the tank. Then turn
the water tank clip on the top of the water tank down wards, so that the clip does not dig the metal when fastening the
water tank down. NOTE: This factory bolt will not be reused.
2. You have been provided with a couple sets of 2’’ Velcro cookies. These are used for the front right of the water tank
to help support the uneven shape of the factory water tank.
Place a couple on the front part of the water tank closet to the driver fender to make contact with the factory water
tank and the new stainless cover.
3. Now place the new cover over the water tank and align the bolt hole with the one on the cover. Make sure to place
the yellow spacer between the metal and the plastic on the water tank, where the bolt will be fastened using the pan
head screw provided. Make sure to put the white socket clip on before you tighten the bolt down this will be used to
snap the chrome cap cover onto the bolt head. Be carefully not to OVER tighten the screw as this will distort the new
cover. Just snug will be sufficient.
4. You have been provided with a chrome decorative cap cover, simply clean the factory cap with household alcohol and
then swipe once with the adhesive promoter provided then install the chrome cap by using the Velcro attachment
cookies that are attached.
Note: Care must be taken when cleaning your sills. It is a good idea to lightly dust your sills with a clean soft cloth
first in order to prevent any particles from scratching them. Then wipe (using a new clean soft cloth or bounty paper
towel) with a good quality streak free glass cleaner.
If you have any questions during installation please call American Car Craft at 727 861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520