22 telepen parameters, 1 type of code, 2 check digit transmission – SCANTECH ID (Champtek company) LG700BT User Manual
Page 64: 3 setup code length, Telepen parameters, Type of code, Check digit transmission, Setup code length
Advertising
56
4.22
Telepen Parameters
4.22.1
Type of Code
<Telepen ASCII ON>
Telepen Numeric
4.22.2
Check Digit Transmission
Do Not Calculate Check Digit
Calculate Check Digit and Transmit
<Calculate Check Digit and Not
Transmit>
4.22.3
Setup Code Length
To set the fixed length: (2 sets available)
1.
Scan the “Begin” programming code of the desired
set
2.
Go to the Decimal Value Table in Appendix A. Scan
programming codes that represent the length to be
read.
3.
Scan the “Complete” programming code of the desired
set.
Repeat the steps 1 – 3 to set additional length.
Advertising