LiftMaster J door operator - Manual (Page 43)

43
ACCESSORIES
OPEN
OPEN
OPEN
OPEN
CLOSE
OPEN
OPEN
CLOSE
STOP
OPEN OPEN
373LM
371LM
65-8202
65-5202
3-Button SECURITY✚ ® Remote Control:
Includes visor clip.
1-Button SECURITY✚ ® Remote Control:
Includes visor clip.
Vehicle Detection System:
Pneumatic Sensing Edge Kit with exterior air switch, 2-wire
coil cord and 14' air hose.
Vehicle Detection System:
Pneumatic Sensing Edge Kit with exterior air switch, 2-wire
take-up reel (20' extended) and 14' air hose.
333LM 3-Button Tri-Colored Dip Switch Remote Control :
Includes visor clip.
2-Button Control Station :
Steel enclosure.
1-Button Control Station:
Steel enclosure.
Commercial Protector System ® :
Provides protection on doors up to 45' wide. NEMA-4 rated.
CPS-UN4
3-Button Control Station:
Steel enclosure with Maintenance Alert System.
02-103L
OPEN
Commercial Protector System ® :
Provides protection on doors up to 30' wide.
CPS-U
OPEN
OPEN
ENTRAPMENT PROTECTION DEVICES
REMOTE CONTROLS 315MHz
CONTROL STATIONS
OPTION CARDS
02-102
02-101
ACCESSORIES
CPS-EI Monitored Safety Edge Interface:
For use with the approved 4-wire safety edge (see below).
OPEN
40-34141-1
LMEP2
LMEP1
E1
E2
E3
E4
CPS-EI
OPEN
OPEN
STOP
CLOSE
Key Control Station:
Indoor flush mount, NEMA 1 with Stop button.
02-110
Accessories
Timer Light Status Card:
The TLS option card provides special functionality to
activate and flash auxiliary devices such as lights, bells, and
horns/strobes at various door positions, and to provide
special timer functions.
TLS1CARD
Auxiliary Contact Card:
The Auxiliary Contact option card has both Normally-Open
and Normally-Closed contacts that actuate when the door is
idle, opening, or closing.
AUXCARD
65ME1234 Miller ME123 4-Wire Monitored Safety Edge:
For sectional or rolling doors.
65ME110 Miller ME110 4-Wire Monitored Safety Edge:
For rolling grilles and counter shutters.
Cast iron bracket to mount J, H, DH, DJ, and GH side mount
operators on end bracket of a rolling door or grill. For vertical or
horizontal mount on either front or top of coil. Cannot be welded.
Heavy gauge steel bracket for vertical or horizontal mount on either
front or top of coil on a rolling door. Has a variety of mounting hole
patterns compatible with many OEM manufacturers. For use with J,
H, DJ, and DH operators. May be welded.
08-9098
MOUNTING BRACKETS
OPEN
OPEN
10-12360
Same as 08-9098, but with adapter plate to hold mounting bolts in
place for easy mounting.
Heavy gauge steel bracket for vertical or horizontal mount on either
front or top of coil on a rolling door. May be welded. For use with J,
H, DJ, and DH operators.
Same as 1A4324, but with adapter plate to hold mounting bolts in
place for easy mounting.
08-9098EZ
1A4324
1A4324EZ
OPEN
Operator Cover:
For use with wall-mounted J, H, GH, DH or DJ operators.
Measures 31" x 19" x 18" (L x W x D). Assembly required.
Recommended for damp environments where direct spray is
present. Required when the operator is installed less than 8
feet above the floor.
1A3982
OPEN
OPEN
Antenna Extension Kit:
The antenna extension kit can be used with EXT-ANT for
maximum radio receiver range.
86LM (15')
86LMT (25')
MISCELLANEOUS
For 1" shafts. Recommended to properly tension drive chain
between operator shaft and door shaft. 71-6023
71-6125 Same as 71-6023, but for 1-1/4" shafts.
For Jackshaft Type Operators CHAIN TENSIONERS
65ME123C U-Shaped Mounting Channel:
For 65ME1234 edge when installed on sectional doors.
65ME123C1 T-Shaped Mounting Channel:
For 65ME1234 edge when installed on rolling doors. Fits between
L-shaped angles used to construct a bottom bar on rolling doors.
65ME123CA3 L-Shaped Mounting Channel:
For 65ME1234 edge when installed on sectional doors.
MOUNTING CHANNELS
CPS3CARD Option Logic Board:
For use when more than one set of photoelectric sensors are
required. Also available pre-packaged with a second set of
photoelectric sensors; see CPS3 or CPS3-N4 in Commercial Door
Operator Product and Accessories Price List for more information.
MONITORED
NON-MONITORED
OPEN
WPB3LM3
WPB1LM3
Wireless 3 Button Control Station SECURITY✚ ® :
Rugged composite housing. (Wireless controls cannot be used in
place of hard wired controls.)
Wireless Single Push Button Control SECURITY✚ ® :
Rugged composite housing. (Wireless controls cannot be
used in place of hard wired controls.)
1 2
4 5
7 8
* 0
3
6
9
#
WKP5LM3 (5 4-digit entry codes)
WKP250LM3 (250 4-digit entry codes)
Wireless Access Control Keypads SECURITY✚ ® :
Rugged composite housing. (Wireless controls cannot be
used in place of hard wired controls.)
LiftMaster offers a variety of SECURITY✚ ® Remote Controls for your
application needs. Single to 4-Button, visor or key chain. Contact
your authorized dealer.