Teledyne 9060Z - Zirconium oxide flue gas oxygen analyzer - Manual (Page 33)

Model 9060Z Manual
33
NOTE: An asterisk (*) on the end of the line identifies the item is enabled by default after a COLD‐START.
6.3.3 Oxygen Display Units
The top line of the display that shows the oxygen measurement can be displayed in either % or ppm
(see chapter 5.2 Oxygen Display Units)
6.3.4 Damping Factor
The oxygen measurement can be damped by averaging successive readings from the probe. This will
smooth out fluctuations in the process gas level and will slow down the reaction time of the
transmitter. The larger the number selected here, the more successive readings are averaged and the
smoother the measurement will be. The damped oxygen value is also used in the calculation of all
other parameters that are based on the oxygen value.
6.3.5 Process Alarms
This function allows the operator to enable and disable process alarms. The process alarm menu
functions will also be hidden if the process alarms are disabled. (See also chapter 7.2.19, Process
Alarms)