Lincoln Electric IM10153 CLASSIC 300 HE - Manual (Page 8)

INSTALLATION
CLASSIC ® 300HE
A-1 A-1
TECHNICAL SPECIFICATIONS - CLASSIC ® 300HE
Make/Model Description Speed (RPM) Displacement Starting Capacities
System
3 Cylinder
24.8HP (18.5kW) 91.47 cu. in 12VDC battery
Naturally Aspirated (1.56 ltrs) (Group 24, 650
Kubota Water-Cooled High Idle 1800 cold crank amps)
D1503-M Diesel Engine Low Idle 1440 Bore x Stroke 1.4 KW Starter
EPA Tier 4 Cast Iron Cylinder, Full Load 1800 40 A. Alternator
Compliant Block/Crankcase 3.27” x 3.64” w/ built in reg. Oil: 5.9 Qts., 5.6L
88mm x 92.4mm
Coolant: 7.82 Qts. 7.4L
INPUT - DIESEL ENGINE
RATED OUTPUT @ 104°F(40°C) - WELDER
MODEL HEIGHT WIDTH DEPTH WEIGHT
45.5 in. (2) 24.3 in. 62.8 in. 1371lbs.
(1156 mm) (616 mm) (1594 mm) (622kg)
RATED OUTPUT @ 104°F(40°C) - GENERATOR
DESCRIPTION RATED DC OUTPUT* Duty DC CURRENT RANGE
VOLTS @ RATED AMPS CYCLE Fine Adjustments in each Range
40-350 Amps
220-Max.
300 Amp DC Welder 30V @ 250A 100% 160-240
All Copper Windings 32V @ 300A 60% 120-190
Pure DC Power Generator 90V DC Max. OCV @ 1800RPM 80-130
Min.-90
Auxiliary Power (1)
3,000 Watts Continuous, 60 Hz AC
26 Amps @ 120V
13 Amps @ 240V
PHYSICAL DIMENSIONS
*
Based on a 10 min. period.
(1) Output rating in watts is equivalent to volt-amperes at unity power factor. Output voltage is within ± 10% at all loads up to
rated capacity. When welding, available auxiliary power will be reduced.
(2) Height to top of exhaust elbow.
K3198-1 CSA @ Without
Wire Feed Module
Fuel:
16 gal.(60.6 L.)