Yokogawa EJA115 - Manual (Page 30)

IM 01C22T03-00E 5-8
5. CONFIGURATION
5.6 Output Analog Input 1 Setup
In the DTM Works window, double-click the [Output]
folder.
Click the [Analog Input 1] folder.
5.6.1 Fail Safe Mode
Fail Safe Mode defines the Output Value and Status
(Quality) if a device breaks down. Select Fail Safe
Mode, and press the Enter key to confirm the data.
When selecting “Default Value is used as Output
Value”, enter the desired values for the Fail Safe
Default, and press the Enter key to confirm the data.
Table 5.5 Fail Safe Mode
T0505.EPS
UNCERTAIN
Substitute Value
Default value is used as
output value Fail Safe Default
Value Value
Fail Safe Mode Output Value and Status(Quality)
Status(Quality)
Value
Status(Quality)
Value
Status(Quality)
Storing last valid output
value Last stored valid
OUT value
UNCERTAIN Last
Usable Value
The calculated output
value is incorrect wrong calculated
value
BAD_*(* as
calculated)
Figure 5.15 Fail Safe Mode Setup