Advantech EKI-1351 - Manual (Page 22)

EKI-1351/1352 User Manual 16
2.3.4 Switch Settings
Normal Mode (Normal)
In normal use, you should move the switch to Normal Mode (Normal), and use the
configuration utility to configure EKI-1351/1352 for different BSS --- Infrastructure
mode or Ad hoc mode.
Diagnostic Mode (Diag.)
If your network connection is broken or you forgot your WLAN serial device server
settings, or you forgot the WEP key, you can move the switch to Diagnostic Mode
(Diag) to rebuild the settings and connection. The default settings in the Diagnostic
Mode as Table 2.2 are fixed. You can connect the host PC and the WLAN serial
device server by the default settings, and then you can reset all the network
parameters. After rebooting the system, the parameters you set will be applied into
Normal Mode. All the modifications will not affect the default settings of Diagnostic
Mode. That means you can always see the same settings while you enter the
Diagnostic Mode every time.
Table 2.2: Default Settings of Diagnostic Mode
Diagnostic Ad Hoc Mode Diagnostic Infrastructure Mode
SSID WLAN ANY
Channel 10 N/A
WEP None None
Enter Way 1. Power off
2. Put the switch at Diagnostic
Mode
3. Power on and wait for 6 to 10
seconds for rebooting, then the
WLAN serial device server will
be in Diagnostic Ad Hoc Mode
1. Power off
2. Put the switch at Normal Mode
3. Power on and wait for 6 to 10 seconds
for rebooting
4. Put the switch to the Diagnostic Mode,
and then wait for about 5 seconds until the
signal LED will start to flash for 10
seconds. During the 10 seconds interval,
you have to put the switch back to Normal
Mode, and the WLAN serial device server
will reboot to Diagnostic Infrastructure
Mode. (*Note: If you don’t put the switch
back to Normal Mode during the 10
seconds interval, the WLAN serial device
server will reboot to Diagnostic Ad Hoc
Mode.)