Lincoln Electric IM491 PRO-CUT 125 - Manual (Page 34)

– 34 –
FIGURE 1- SINGLE VOLTAGE
FIGURE 1- DUAL & TRIPLE VOLTAGE
3. REMOVE HEX NUTS AND POSITION LINKS AS SHOWN.
REPLACE AND TIGHTEN ALL HEX NUTS.
NOTE: MACHINES ARE SHIPPED FROM FACTORY CONNECTED
THE LINCOLN ELECTRIC CO., CLEVELAND, OHIO U.S.A.
2. CONNECT TERMINAL MARKED TO GROUND PER
NATIONAL ELECTRICAL CODE.
LINK
LINK POSITIONS 575 V.,60HZ.
INPUT SUPPLY CONNECTION DIAGRAM
FOR SINGLE VOLTAGE MACHINE.
M17491
W
V
U
T3
T2
T1
4
5
6
7
8
9
10
11
12
U
V
W
GND.
1. CONNECT U, V, & W INPUT SUPPLY LINES TO STUDS
MARKED U, V, & W ON RECONNECT PANEL.
1 - 1 4 - 9 4 B
FOR 575 VOLTS
3. REMOVE HEX NUTS AND POSITION LINKS AS SHOWN.
REPLACE AND TIGHTEN ALL HEX NUTS.
NOTE: MACHINES ARE SHIPPED FROM FACTORY CONNECTED
THE LINCOLN ELECTRIC CO., CLEVELAND, OHIO U.S.A.
2. CONNECT TERMINAL MARKED TO GROUND PER
NATIONAL ELECTRICAL CODE.
LINK LINK POSITIONS
{
LINK LINK POSITIONS
{
LINK LINK POSITIONS 440 V.,50HZ.
460 V.,60HZ.
380 V.,50HZ.
220 V.,50HZ.
230 V.,60HZ.
FOR 440 (OR 460) VOLTS
INPUT SUPPLY CONNECTION DIAGRAM
FOR TRIPLE VOLTAGE MACHINE.
M16437
W
V
U
T3
T2
T1
4
5
6
7
8
9
10
11
12
W
V
U
T3
T2
T1
4
5
6
7
8
9
10
11
12
W
V
U
T3
T2
T1
4
5
6
7
8
9
10
11
12
{
U
V
W
U
V
W
U
V
W
GND.
GND.
GND.
1. CONNECT U, V, & W INPUT SUPPLY LINES TO STUDS
MARKED U, V, & W ON RECONNECT PANEL.
5 - 2 8 - 9 3