Brother HL-6180DWT - Manual (Page 6)

5
Quick reference for barcode control commands
2
Barcode, expanded character, line block drawing and box drawing offset in
X-axis
2
n = ‘xnnn’ or ‘Xnnn’
This parameter shows the offset from the left margin in the ‘u’- or ‘U’-specified unit.
Barcode & expanded character offset in Y-axis
2
n = ‘ynnn’ or ‘Ynnn’
This parameter shows the downward offset from the current print position in the ‘u’- or ‘U’-specified unit.
Barcode, expanded character, line block drawing and box drawing height
2
n = ‘hnnn’, ‘Hnnn’, ‘dnnn’, or ‘Dnnn’
1 EAN13, EAN8, UPC-A, ISBN (EAN13, EAN8, UPC-A), ISBN (UPC-E): 22 mm
2 UPC-E: 18 mm
3 Others: 12 mm
Expanded characters i 2.2 mm (preset)
Line block drawing and box drawing i 1 dot
This parameter shows the height of barcodes or expanded characters as shown above. It can start with ‘h’,
‘H’, ‘d’, or ‘D’. The height of barcodes is shown in the ‘u’- or ‘U’-specified unit. The default setting of the
barcode height (12 mm, 18 mm or 22 mm) is determined by the barcode mode selected by ‘t’ or ‘T’.
Expanded character width, line block drawing and box drawing
2
n = ‘wnnn’ or ‘Wnnn’
Expanded character i 1.2 mm
Line block drawing and box drawing i 1 dot
This parameter shows the width of expanded characters as shown above.
Expanded character rotation
2
n = ‘a0’ or ‘A0’ ‘Upright (preset)
n = ‘a1’ or ‘A1’ ‘Rotated 90 degrees
n = ‘a2’ or ‘A2’ ‘Upside down, rotated 180 degrees
n = ‘a3’ or ‘A3’ ‘Rotated 270 degrees