Brother HL-4040CDN - Manual (Page 199)

Appendix (for Europe and Other Countries)
190
B
Important information: regulations
B
Radio interference (220 to 240 volt model only)
B
This printer follows EN55022 (CISPR Publication 22)/Class B.
Before you use this product, make sure that you use one of the following interface cables.
1 A shielded parallel interface cable with twisted-pair conductors and that it is marked IEEE 1284 compliant
(HL-4050CDN / HL-4070CDW only).
2 A USB cable.
The cable must not be more than 2 meters long.
IEC 60825-1 specification (220 to 240 volt model only)
B
This printer is a Class 1 laser product as defined in IEC 60825-1 +A2:2001 specifications. The label shown
below is attached in countries where it is needed.
This printer has a Class 3B laser diode which produces invisible laser radiation in the laser unit. You should
not open the laser unit under any circumstances.
Caution
B
Use of controls or adjustments or performance of procedures other than those specified in this User’s Guide
may result in hazardous invisible radiation exposure.
For Finland and Sweden
B
LUOKAN 1 LASERLAITE
KLASS 1 LASER APPARAT
Varoitus!
B
Laitteen käyttäminen muulla kuin tässä käyttöohjeessa mainitulla tavalla saattaa altistaa käyttäjän
turvallisuusluokan 1 ylittävälle näkymättömälle lasersäteilylle.
Varning
B
Om apparaten används på annat sätt än i denna Bruksanvisning specificerats, kan användaren utsättas för
osynlig laserstrålning, som överskrider gränsen för laserklass 1.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT