Brother MFC 990cw - Manual (Page 13)

13
Set up the cordless handset (MFC-990CW only)
16
Install the battery
a
Insert the connector a of the battery b in the
direction shown below.
b
Place the battery in the position shown.
c
Install the battery cover by sliding it onto the
back of the handset.
d
Charge the battery by leaving the cordless
handset in the cradle for at least 12 hours
before you use it.
You can continue to set up the handset during
this time.
17
Charge the battery
a
Place the cordless handset on the cradle with
the dial pad facing forward.
18
Set your country on the
cordless handset
The first time you install the battery, you must set your
country so that the cordless handset works correctly
on local telecommunication lines.
a
The LCD shows:
Set Country
Press OK Key
b
Press Menu/OK.
c
Press a or b to choose your country.
Press Menu/OK.
d
Press 1 to confirm.
Note
Be careful that you do not catch the battery
connector cord.
1
2
Note
If your battery charge level is getting low, you
should charge the battery. You can see the
battery charge level indicator at the bottom right of
the LCD.
Note
The LCD of the handset will display
“Searching for Base Unit” or
“Base Unit not detected” until the initial
setup of the machine is complete.