Canon REALIS WUX10 MARK II D - Manual (Page 100)

Setting Various Function
100
Setting a Password
[Other settings] - [Password settings]
Disables the projector unless the correct pass-
word is entered.
Press the OK button to accept your setting and
then press the MENU button.
• [Off] is the factory default.
• You cannot set [On] unless you have com-
pleted [Register password].
Once you set a password, the password entry
screen appears at power-on.
Enter a 4-digit password with [ ] / [ ] / [<] / [>].
If the password is valid, the projection starts. If
you enter a wrong passwords three times, the
power will be turned off.
• The power is also turned off if no password is
inputted for 3 minutes.
Registering a Password
[Other settings] - [Register password]
You can register a password for starting
projection.
Press the OK button after selecting [Reg-
ister password], and the following screen
for registering a password appears:
Enter a 4-digit password using [ ] / [<] /
[ ] / [>] (e.g.,
, <<<<, <>).
The 4-digit password is entered from the
left to right digits, the password is auto-
matically registered.
• Press the MENU button to abort the reg-
istration.
HDMI COMPONENT
DIGITAL PC VIDEO
ANALOG PC
Off The projector can be used even if no password
is entered.
On The projector cannot be used unless you enter
your password.
Other settings
System settings
Password settings
<
<
To Cancel the Password
Turn off the projector and unplug the power
plug. Hold down the MENU button on the top
control and connect the power plug. Make
sure to keep holding down the MENU button
until a beep sounds. The password is can-
celled (the registered password is also reset).
HDMI COMPONENT
DIGITAL PC VIDEO
ANALOG PC
Other settings
System settings
Register password
<
<
< < < < <
<