Connecting the projector to the computer – Canon REALIS WUX10 MARK II D User Manual
Page 37
37
Connecting the Projector
Proje
cti
ng
an
Im
age
Connecting the Projector to the Computer
Connect the projector to the computer.
Before connecting the cables, turn off both the projector and computer.
The digital connection (
) is recommended when projecting a WUXGA or UXGA image
in high quality.
■Connecting to RGB Monitor Output Terminal (analog connection)
Supplied computer connection cable (Input signal type: [ANALOG PC-1] -
VGA cable (Input signal type: [ANALOG PC-2] -
)
• Use full connected VGA cable in which all pins are connected; otherwise, an image will be
projected improperly.
• Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor
turns down the sound.
Computer
Monitor output
terminal
(mini D-sub 15-pin)
Audio output terminal
(AUDIO OUT)
Supplied computer connection cable
To input a corresponding
audio signal:
Commercial audio cable
To ANALOG PC-1/
DVI-I IN
To AUDIO IN
Projector
Monitor output
terminal
(mini D-sub 15-pin)
Audio output terminal
(AUDIO OUT)
To input a corresponding
audio signal:
Commercial audio cable
Commercial VGA cable
To AUDIO IN
To ANALOG PC-2/
COMPONENT IN
Computer
Projector