LG BD430 - Manual (Page 22)

22
Installation
Connecting to the AC power cord
This projector uses nominal input voltages of 100-
240 V AC and it automatically selects the correct
input voltage. It is designed to work with a single-
phase power system having a grounded neutral
conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being
supplied, consult your authorized dealer or service
center.
Connect the projector with all peripheral
equipment before turning it on.
Connect the AC power cord
(supplied) to the projector.
The AC outlet should be near this equipment and must be easily accessible.
√ Note:
Unplug the AC power cord when the projector is not in use. When the projector is connected to an outlet
with AC power cord, it is in stand-by mode and consumes a little electric power.
Note on the power cord
AC power cord must meet the requirements of the country where you use the projector. Confirm the AC
plug type with the chart below and proper AC power cord must be used.
Projector side
AC outlet side
For the U.S.A. and
Canada
For Continental
Europe
For the U.K.
√ Note:
● Using incorrect power cord may influence the product performance, or even cause hazards like an
electric shock or fire. To ensure the product performance and security, please apply the cable of the
same model with the original one.
● Common connecting cables include the AC power cord, various RGB cables, video cable,and serial
control cable.
To power cord
connector on your
projector.
Ground
To the AC outlet.
(110 V AC)
To the AC outlet.
(200 - 240 V AC)
To the AC outlet.
(200 - 240 V AC)
Ground