LG BD430 - Manual (Page 55)

55
Maintenance
Replacing the lamp
When the service life of the projection lamp is
over, the icon suggests that the lamp needed to
be replaced will appear on the screen, and the
LAMP indicator on the top control will lights red. In
this case, you should immediately replace it with
a new one of the same model. The lighting time of
the LAMP indicator is subject to the lamp mode.
To replace the lamp, follow the steps below:
1. Power off the projector and unplug the power
cord. Then let the project cool for at least 45
minutes.
2. Loosen the screws on the lamp cover and open
the cover.
3. Loosen the two screws that secure the lamp. Lift
the lamp out of the projector by using the handle.
4. Replace the lamp with a new one and secure
the two screws.
Make sure that the lamp is set properly. Close
the lamp cover and secure the screw.
5. Plug the AC power cord and power on the
projector.
As temperature inside the projector is high,
you should cool the projector for at least 45
minutes before you open the lamp cover.
When the lamp isn’t illuminated, it may indicate that the lamp has been damaged.
When you replace the lamp in a projector installed on the ceiling, you should stand beside
the lamp cover but not under it; for the broken glass may fall down to hurt you. To do that,
remove the lamp cover gently to avoid being hurt by the dropped glass. If glass drops into
your eyes or mouth, you should see the doctor immediately.
For the sake of safety, only use the lamp of
the same model. Never drop the lamp onto the
ground nor touch the glass bulb! The glass can
shatter and hurt.
CAUTION CAUTION
CAUTION
Lamp cover
Screw
Handle
Screw
Screw
Lamp
AUTO INPUT
OK
/
MENU
Top Control
LAMP REPLACE
indicator lights
red.
Lamp replacement icon
Replace the lamp