Sles – HP NC532m Dual Port 10GbE Multifunction BL-c Adapter User Manual
Page 15
Installation and configuration 15
If an older version of the package exists, remove the older iscsi-initiator-utils RPM package using the
following command:
# rpm -e iscsi-initiator-utils
Verify that the old package has been removed using the following command:
# rpm -q iscsi-initiator-utils
5.
Install the iscsi-initiator-utils binary RPM package using the following command:
# rpm -ivh RPMS/<arch>/iscsi-initiator-utils-<version>.<arch>.rpm
6.
Start the iscsi daemon using the following command:
#/etc/init.d/iscsi start
Uninstalling the HP NC-Series iSCSI offload initiator utilities for Red Hat
If you need to uninstall the HP NC-Series iSCSI offload initiator utilities for Red Hat, use the following
command:
# rpm -e iscsi-initiator-utils-<version>
SLES
Install HP NC-Series iSCSI Offload Initiator Utility for SLES
Install the HP NC-Series iSCSI Offload Initiator Utilities for SLES RPM package:
1.
Change to the linux\iscsi-offload directory on your hard drive and use the following command:
# rpm -ivh open-iscsi-<version>.src.rpm
2.
Build the binary RPM for the open-iSCSI initiator utility using the following commands:
# cd /usr/src/redhat
# rpmbuild -bb SPECS/open-iscsi.spec
3.
Stop the iscsid daemon using the following command:
#/etc/init.d/open-iscsi stop
4.
Check for the existence of a current version of the open-iscsi initiator utilities package using the
following command:
# rpm -q open-iscsi
If an older version of the package exists, remove the older open-iscsi initiator utilities RPM package
using the following command:
# rpm -e open-iscsi
Verify that the old package has been removed using the following command:
# rpm -q open-iscsi
5.
Install the open-iscsi binary RPM package using the following command:
# rpm -ivh RPMS/<arch>/open-iscsi-<version>.<arch>.rpm
6.
Start the open-iscsi daemon using the following command:
#/etc/init.d/open-iscsi start
Uninstalling the HP NC-Series iSCSI offload initiator utilities for SLES
If you need to uninstall the HP NC-Series iSCSI Offload Initiator Utilities for SLES RPM, use the following
command:
# rpm -e open-iscsi-<version>