HP ProLiant BL10e G2 Server Blade - Manual (Page 13)

The setup process begins. Allow the entire setup process to complete, including any
requested restarts, before interrupting this process or powering down the server. After
the initial setup is complete, the server can be configured to your individual needs.
IMPORTANT: Because of some driver installation needs, the system might complete the
driver installation after the first required logon. Do not perform any actions on the Configure
Your Server screen. If additional drivers are loaded, the system completes the driver
installation and automatically reboots. The next time the system presents a logon prompt,
log on normally and proceed to use the new operating system.
Automatic Configuration
Some parts of the setup process are automatically configured, and these screens
do not appear. In the future, for information about changing any preconfigured
information, refer to the operating system online Help. Of the screens that are
automatically configured, the following might require later changes.
Licensing Mode
The server licensing mode is set to per-seat. To change the licensing mode to
per-server after the initial operating system installation completes, refer to the
“Changing Licensing Mode” section in this document.
If additional licenses were purchased, apply the additional licenses after the initial
operating system installation completes. If the server is set to per-seat mode, refer to
the “Adding Licenses in Per-Seat Mode” section in this document. For information
about adding licenses if the server is set to per-server mode, refer to the online Help
or the operating system documentation.
Administrator Password
This password has been intentionally left blank. Change the password immediately
after the software installation is complete. Do not change the Administrator password
during the initial setup when entering the computer name, because changing the
password at this time can cause the automated installation process to abort. For
information about changing the Administrator password after the installation has
been completed, refer to the “Changing the Administrator Password” section.
HP Factory-Installed Operating System Software for Microsoft Windows 2000 Server User Guide 13
HP CONFIDENTIAL
Writer: Michele Richardson File Name: 280154-007.doc
Codename: CTO Part Number: 280154-007 Last Saved On: 10/7/03 2:48 PM