HP XP P9000 for Compatible High Perf FICON Connectivity Software - Manual (Page 66)

4. Select the WWN tab.
5. In the lower-left tree, double-click the PFC group ( ) that contains the host bus adapter to be
deleted.
6. Below the PFC icon, right-click the icon the host bus adapter ( ) you want to delete.
7. Select Delete WWN from the pop-up menu.
The selected host bus adapter icon is deleted from the tree.
8. Click Apply. The settings on the window are applied to the storage system.
Switching priority of an PFC group
All the host bus adapters (HBAs) in one PFC group must be of the same priority. Prioritized WWNs
and non-prioritized WWNs cannot be mixed in one PFC group.
You can use an PFC group to switch priority of multiple HBAs from prioritized to non-prioritized,
or vice versa.
1.
Click Reports > Performance Monitor> Performance Control to open the Performance Control
window.
2. Click to change to Modify mode.
3. In the Performance Control window, click Performance Control. The Performance Control main
window appears.
4. Select the WWN tab.
5. In the lower-left tree, select and right-click an PFC group ( ).
6. Do one of the following:
•
To switch priority from prioritized to non-prioritized, select Prio ->> Non-Prio from the
pop-up menu.
•
To switch priority from non-prioritized to prioritized, select Non-Prio ->> Prio from the
pop-up menu.
7. Click Apply. The settings in the window are applied to the storage system.
Setting an upper-limit value to HBAs in an PFC group
If all the host bus adapters in an PFC group are non-prioritized WWNs, you can set an upper limit
value to HBA performance (i.e., I/O rate or transfer rate). You can assign one upper limit value
for one PFC group.
For example, suppose that the upper limit value 100 IOPS is assigned to an PFC group consisting
of four host bus adapters. If the sum of the I/O rate of the four HBAs reaches 100 IOPS, Performance
Control controls the system so that the sum of the I/O rates will not exceed 100 IOPS.
1.
Click Reports > Performance Monitor> Performance Control to open the Performance Control
window.
2. Click to change to Modify mode.
3. In the Performance Control window, click Performance Control. The Performance Control main
window appears.
4. Select the WWN tab.
5. In the lower-left tree, select and right-click the Storage System folder or an PFC group ( ).
66 Performance Control operations