HP XP P9000 for Compatible High Perf FICON Connectivity Software - Manual (Page 67)

6. If you selected the Storage System folder, take the following steps:
•
Select IOPS or MB/s from the list at the upper-left corner of the list. Select IOPS if you
want to assign an upper limit to the I/O rate. Select MB/s if you want to assign an upper
limit to the transfer rate.
•
To assign an upper limit to the I/O rate, enter the upper limit value in the IOPS column
of the list. To assign an upper limit to the transfer rate, enter the upper limit value in the
MB/s column of the list.
TIP: If you cannot see the IOPS or MB/s column, scroll the list to the left. The column is
located at the right side of the list.
If you selected an PFC group ( ), take the following steps:
•
Right-click the selected PFC group and then select Change Upper Limit from the pop-up
menu. The Change Upper Limit dialog box opens.
•
To assign an upper limit to the I/O rate, enter the upper limit value and then select IOPS
from the list. Next, select OK. To assign an upper limit to the transfer rate, enter the upper
limit value and then select MB/s from the list. Next, select OK.
7. In the Performance Control main window, click Apply. The settings in the window are applied
to the storage system.
To confirm an upper limit value specified for each PFC group, select the Storage System folder
in the lower-left tree of the WWN tab. The PFC groups are displayed in the list and you can
confirm each upper limit value.
Renaming an PFC group
1. Click Reports > Performance Monitor> Performance Control to open the Performance Control
window.
2. Click to change to Modify mode.
3. In the Performance Control window, click Performance Control. The Performance Control main
window appears.
4. Select the WWN tab.
5. In the lower-left tree, select and right-click an PFC group ( ).
6. Select Rename PFC Group from the pop-up menu. The Rename PFC Group dialog box opens.
7. Enter the new name and select OK.
WWN tab operations 67