Power baselines and zones, Power commands, Displaying the rack power status – HP ProLiant DL170e G6 Server User Manual
Page 49
Power capping 49
Power baselines and zones
The power baseline cannot be created with respect to a zone. The baseline is a singular separate entity that
is saved into the SL-APM EEPROM. Zones can use portions of the established baseline when considering
power caps, but the baseline is established globally.
Power commands
NOTE:
For the power capping feature, you must have SL-APM 1.30 or later. You must also have
an HP ProLiant s6500 Chassis or later with BIOS support required. SL-APM 1.30 does not support
the HP ProLiant DL1000, DL2000, or SL6000 Chassis.
The power commands use the SL-APM port number, the distribution module port number, and server node
port number as input parameters.
In the following figure, the SL-APM port 2 is connected to the SL-APM Distribution Module port 4. The
distribution module port, in turn, is connected to the SL enclosure and server node 8.
Item
Description
1
SL-APM
2
SL-APM Distribution Module
3
SL series enclosure
4
Bay 4 of a 4U chassis SL6500 Scalable System enclosure with eight 1U half-width
nodes
Displaying the rack power status
Enter SHOW POWER, and then optionally the specific SL-APM port, or both the SL-APM and the SL-APM
Distribution Module ports.
For example: