Show power baseline, Show version, Upgrade image – HP ProLiant DL170e G6 Server User Manual
Page 85: Add zone
CLI commands 85
Displays the currently set system time.
Show power baseline
•
Command:
SHOW POWER BASELINE
•
Description:
Reports the currently established baseline data for all chassis that are connected to the SL-APM.
Show version
•
Command:
SHOW VERSION
SHOW VERSION ALL
•
Description:
o
Displays SL-APM firmware copyright, version, build date, and hardware version. Also displays
SL-APM Distribution Module hardware and firmware versions.
o
SHOW VERSION ALL shows the HP Power Management Controller Utility hardware and firmware
versions as well as the license status of all servers in the enclosures.
Upgrade image
•
Command:
o
If using TFTP protocol for upgrading SL-APM, enter:
UPGRADE IMAGE TFTP <ip_address> "<filename>"
o
If using FTP protocol for upgrading SL-APM, enter:
UPGRADE IMAGE FTP <ip_address> "<username>" "<password>" "<filename>"
•
Description:
o
Updates SL-APM firmware using the specified protocol. Protocol can be either FTP or TFTP.
<ip_address> refers to the IP address of a server that contains the file to be transferred, and
filename is the file to be transferred. Following the transfer, SL-APM will be upgraded and reset to
run the new image.
o
The filename must be enclosed in quotes to preserve case.
Add zone
•
Command:
ADD ZONE <zone_name> [[<PORT#> <DMPORT#>]] | [<PORT#> ALL] | [ALL]
•
Description:
Adds one or more chassis to a zone named by <zone_name>. If the zone does not already exist, then
it will be automatically created and the specified chassis will be added.
You can create up to four zones.