HP ProLiant DL170e G6 Server - Manual (Page 89)

CLI commands 89
o Sets the IP addresses where SNMP traps are sent.
You can set up to four SNMP trap destinations. For example, enter:
SET SNMP TRAPDEST x.x.x.x y.y.y.y z.z.z.z a.a.a.a
If you specify NONE, then no trap destinations are set. For example, enter:
SET SNMP TRAPDEST NONE
o SL-APM supports the following SNMP traps:
NOTE: SNMP traps denoted by an * are not supported on the HP ProLiant s6500 Chassis.
— cpqRackNameChanged
— cpqRackEnclosureRemoved
— cpqRackEnclosureInserted
— cpqRackEnclosureFanRemoved *
— cpqRackEnclosureFanInserted *
— cpqRackEnclosureFanFailed
— cpqRackEnclosureFanOK
— cpqRackPowerSupplyFailed
— cpqRackPowerSupplyOK
— cpqRackPowerSupplyRemoved
— cpqRackPowerSupplyInserted
— cpqRackServerBladeRemoved
— cpqRackServerBladeInserted
Enable XML
• Command:
ENABLE XML
• Description:
Turns on XML interface and makes XML queries available on the network using port 80 (HTTP).
You can enable XML, or enable XML secure, but you cannot enable both concurrently.
Enable XML secure
• Command:
ENABLE XML SECURE
• Description:
Turns on XML interface and makes XML queries available on the network using port 443 (HTTPS). This
command uses an encrypted secure socket connection.
You can enable XML, or enable XML secure, but you cannot enable both concurrently.