HP StorageWorks EVA Controller HSG V8.8 Software - Manual (Page 100)

Troubleshooting
100 Command Console V2.5 User Guide
Reconfiguration After Controller Replacement
If you replace a controller in your subsystem, you must reconfigure your Agent’s
storage list to match the new hardware.
Some Graphics Do Not Scale Well with Large Fonts
Display small fonts when using the Client. Some graphics do not scale as well if
large fonts are used.
Starting Client from the Command Prompt
To start the Client with network connections from the command prompt, enter the
following at the command prompt on the Client system:
\path_to_client_directory\swcc.exe -d your_host_system
your_host_subsystem
where -d your_host_system your_host_subsystem is an optional set of
parameters that enables you to specify a system and a subsystem to start the
Client.
For example:
C:\>\Program Files\Compaq\SWCC\swcc.exe -d hostsystem subsystem
If you specify these parameters when the Client opens, the system is selected and
the subsystem is displayed in the Storage window. If the Client is not already
aware of the system and the subsystem, it adds them to the Navigation tree.
Warning Message Windows
You may see warning messages, such as “Command Execution Error” along with
detailed information. These messages indicate problems with the controller, rather
than with the software. The controller is responding to problems in parsing and
executing commands from the Client and Agent.
Virtual Disk Recovery from a Configuration File
If you delete a virtual disk, all the member drives are re-initialized and data is lost.
You cannot restore a virtual disk’s data by changing the configuration. A
configuration file contains information about only the structure of a virtual disk -
it does not store data.