HP ProLiant ML370 G4 Server - Manual (Page 20)

Post-installation tasks 20
9. Enter the following path in the Device Driver Wizard field:
C:\HPDRVRS
10. Click OK. The driver search results should display the appropriate device.
11. If an incorrect device appears, click Back, and reselect the correct device.
12. Click Next to install the driver.
13. Click Finish>Close to return to the Computer Management screen.
Installing client printer drivers
The client printer drivers are preinstalled in the Printers directory located on the disk drive. When
installing printer support for client operating systems, supply the path C:\PRINTERS. For additional
information about installing drivers for network shared printers, refer to the "Printers and Faxes" section of
the help file, which can be accessed by clicking Start and selecting Help and Support.
Event log errors
After the ProLiant Installation Utility is complete, event log error messages related to certain controller
drivers might appear. These messages are expected at this time and do not affect the performance of the
server or the operating system. Possible messages include:
• The device, \Device\scsi\adpul60ml, did not respond within the timeout period.
• The device, \Device\scsi\cpqfcalm1, did not respond within the timeout period.
• Unable to read IO control information from NBT device. Refer to article #Q257760 on the
Microsoft® website (
http://www.microsoft.com ).
Backing up the server
After you complete the software installation and the server is operational, back up the server using a tape
backup system in conjunction with approved tape backup software.
Using ProLiant support software
The PSP for the operating system is automatically installed when the server software is installed. This
software contains device drivers and utilities that take advantage of specific capabilities offered with
ProLiant server products. These drivers are provided for use with ProLiant hardware only. For more
information, refer to the PSP for the operating system located on the disk drive in the C:\PSP directory.
1. Click Start, and select All Programs>Pre-Install Features>ProLiant Support Pack.
2. Follow the on-screen instructions when the setup program is launched.
To manually launch the setup program:
1. Click Start>Run.
2. Enter the following path in the textbox:
C:\PSP\SETUPEX.EXE
3. Click OK.
4. Follow the on-screen instructions when the setup program is launched.