Controlling server power through the clp, Monitoring sensors – HP ProLiant SL165z G7 Server User Manual
Page 30
Using LO100 30
o
Always power up—Powers on the server immediately after power is supplied.
o
Restore to powered state prior to power loss—Powers on the system if the system was in the
powered on state before a loss of power.
o
Power pushbutton or command required to power on system—Causes the server to wait for
external action before powering on the system.
2.
Click Set.
The power restore policy becomes becomes active after a successful BIOS post.
Controlling server power through the CLP
1.
Log in to LO100 CLP as described in the "Logging in to LO100 (on page
)" section.
2.
Change to the system1 target by entering cd system1.
3.
To power on the server, enter start /system1. For example:
i. /./system1/> start /system1
ii. System1 started.
4.
To power off the server, enter stop /system1. For example:
i. /./system1/> stop /system1
ii. System1 stopped.
iii. The -force option can also be used with the stop command. This option forces the
implementation to stop the target, ignoring any policy that might cause the implementation
to normally not execute the command. In remote management processor implementation,
this process is equivalent to a hard power down.
5.
To reset the server, enter reset /system1. For example:
i. /./system1/> reset
ii. System1 reset.
Monitoring sensors
LO100 provides operating system-independent remote monitoring of the current status of major sensors of
a target server including system temperature, fans, and voltage. You can view the data for this feature on
the Monitoring Sensors Page through a web browser or through the BIOS Setup Utility.