HP ProLiant xw460c Blade Workstation - Manual (Page 31)

Hardware options installation 31
• Bank A and bank B must contain FBDIMMs with identical part numbers. If installed, bank C and
bank D must also contain FBDIMMs with identical part numbers.
When using mirrored memory mode, FBDIMMs must be populated as specified in the following table:
Configuration Bank A
1A and 3A
Bank B
5B and 7B Bank C
2C and 4C Bank D
6D and 8D
1 X X — —
2 X X X X
After installing FBDIMMs, use RBSU to configure the system for mirrored memory support (" Configuring
mirrored memory " on page 47 ).
Installing FBDIMMs
To install the component:
1. Power down the server blade (on page 13 ).
2. Remove the server blade (on page 14 ).
3. Remove the access panel (on page 14 ).
4. Install the FBDIMM.
5. Install the access panel (on page 15 ).
6. Install the server blade (" Installing a server blade " on page 18 ).
7. Power up the server blade (on page 13 ).
8. Use RBSU to verify the configuration (" HP ROM-Based Setup Utility " on page 45 ).
Mezzanine card option
Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The
card type determines where it can be installed in the server blade.
• Install Type I mezzanine cards on either mezzanine 1 connector or mezzanine 2 connector.
• Install Type II mezzanine cards only on mezzanine 2 connector.