HP 3PAR Application Software Suite for Oracle Licenses - Manual (Page 103)

7 Using Remote Copy with Recovery Manager
Overview
HP 3PAR Remote Copy Software helps you safeguard against disasters by copying (syncing) virtual
volumes from one HP 3PAR StoreServ Storage system to another. HP 3PAR Recovery Manager
Software for Oracle is tightly integrated with HP 3PAR Remote Copy Software to specifically protect
Oracle databases by copying (syncing) Oracle datafiles and archive log virtual volumes from one
HP 3PAR StoreServ Storage system (local/primary) to another (remote/secondary), and then
creating a consistent snapshot image (Virtual Copy) of an Oracle database on the local and remote
HP 3PAR StoreServ Storage systems. This allows rapid recovery to any previous point in time in
case of disaster.
For more information on HP 3PAR Remote Copy Software, see the HP 3PAR Remote Copy Software
User’s Guide.
Recovery Manager for Oracle’s Remote Copy Requirements
Before using the Recovery Manager for Oracle Remote Copy utility, the following must be set up:
•
Primary/local and secondary/remote servers must be correctly configured.
•
Remote Copy links among nodes within the servers must be set up and Remote Copy targets
related to the servers must be created. Recovery Manager for Oracle only supports the
mirror_config
policy (default) for the involved Remote Copy targets.
•
If Linux LVM or Symantec VxVM is used, all volumes that are in the same disk group as the
datafiles or archive log destinations must be admitted to the same Remote Copy group.
•
The Remote Copy groups must be started and in synchronized status.
•
For Remote Copy setups in synchronous and asynchronous periodic mode:
The Oracle datafile and archive log virtual volumes can be on the same or separate
Remote Copy groups. ◦
◦ Volumes used by the Oracle redo logs and control files must reside on a separate Remote
Copy group from the datafile and archive log Remote Copy groups.
•
For Synchronous Long Distance Remote Copy setups:
The Oracle datafile and archive log virtual volumes can be on the same or separate
Remote Copy groups. ◦
◦ Each Remote Copy group must have two targets. The same set of database volumes must
belong to two Remote Copy groups (with the same name). One group is for the
asynchronous periodic target, and the other group is for the synchronous target.
◦ The Oracle online redo log volumes must be included in one of the database Remote
Copy groups, excluding the Oracle datafile and archive log Remote Copy groups. This
allows for a successful failover if needed. If the Oracle online redo log volumes are
included in either the Oracle datafile Remote Copy group or the archive log Remote Copy
group, Recovery Manager for Oracle will fail.
•
Refer to the HP 3PAR Remote Copy Software User’s Guide to set Remote Copy targets, links,
and groups.
After the above has been set up, a Recovery Manager for Oracle configuration file must be created.
There are two ways to create a configuration file.
Overview 103