HP Server tc3100 series - Manual (Page 46)

Chapter 6 Setting Up NT Graphics Console Redirection Using pcAnywhere
Installing pcAnywhere on the Server
To enable console redirection (the ability to redirect what's graphically displayed
on your server) either over the LAN or via modem, you must first install the
pcAnywhere host software, included with your system, on your HP Server.
NOTE Remember that the HP Server Remote Management Card
software license authorizes a single administrator for each
copy of software (including Symantec's pcAnywhere).
Console Redirection Over a LAN
If you want console redirection (remote control) of your server over a LAN
(instead of using a modem with pcAnywhere), you must have TCP/IP software
installed on your server. TCP/IP is available with the standard Windows NT
product.
Installing pcAnywhere Server Software
Installing pcAnywhere at the server requires administrator privileges in order to
configure the program's communications features. Your server must be running
either Windows NT 4.0 or Windows 2000.
To install the pcAnywhere software on your Windows server:
1. Log in to Windows with administrator privileges. You need to be the
system administrator, or have an account that belongs to the administrator
group.
2. Insert the HP Netserver Navigator CD (supplied with the HP Server
Remote Management Card) in the CD-ROM drive.
3. If you want to run pcAnywhere via the modem connected to the HP Server
Remote Management Card, install the appropriate serial driver by running
one of the following driver setup programs.
For Windows NT 4.0, the driver is located in:
x:\ttrc2\us\nt40drvr\setup.exe
For Windows 2000, the driver is located in:
x:\ttrc2\us\win2kdrvr\install.exe
where x: is the letter of your CD-ROM drive. Follow the on-screen setup
instructions.
40