HP XP7 Storage - Manual (Page 94)

Table 51 Parameters for the FCESTABL command (FlashCopy SE / Suspending write operations to
S-VOLs)
Description Value Parameter
Suspend the write operations from the host to S-VOLs. Although if you establish a
relationship specifying extents, the ACTION parameter will suspend the write operation
to the whole volume. FREEZE ACTION
The following example shows how to use the FCESTABL command to suspend write operations
to an S-VOL when you establish a FlashCopy SE relationship. In this example, the FCESTABL
command creates a relationship between volumes (devices) numbered 4202 and 4203, and at
the same time suspends write operations from the host to the source device numbered 4202.
Example 1 FCESTABL command (Compatible FlashCopy SE / ACTION specified)
FCESTABL SDEVN(X'4202') TDEVN(X'4203') ACTION(FREEZE)
SETGTOK(YES) MODE(NOCOPY)
To resume writing to S-VOLs, issue the FCWITHDR command with the ACTION parameter specified.
If a timeout occurs before you issue the FCWITHDRAW command, write operations resume. The
default setting of timeout is 120 seconds (2 minutes).
CAUTION: Remember that the state-change-pending time (SCP time) of Compatible FlashCopy
SE and Continuous Access Synchronous Z is the same. Therefore, when you are going to change
the state-change-pending time of Compatible FlashCopy SE, you need to decide the setting value,
considering that the state-change-pending time of Continuous Access Synchronous Z will also be
changed to the same value. For information about the state-change-pending time of Continuous
Access Synchronous Z, see the HP XP7 Continuous Access Synchronous for Mainframe Systems
User Guide.
Commands for establishing relationships
To establish Compatible FlashCopy SE relationships, you use one of the following sets of commands:
•
PPRC TSO
•
DFSMSdss
•
ICKDSF
•
z/VM CP
Using PPRC TSO to establish relationships
The following steps show how to use PPRC TSO with the FCESTABL command when you establish
Compatible FlashCopy SE relationships.
1.
Specify FCSETGTOK(YES) and MODE(NOCOPY), and then execute the FCESTABL command.
The EXTENTS, XTNTLST, and XXTNTLST parameters cannot be specified for Compatible
FlashCopy SE.
2. Change the VOLSER of the T-VOL.
When the VTOC is copied, the VOLSER of the S-VOL and T-VOL become the same. The VOLSER
of the T-VOL must be changed before varying the T-VOL back online.
The following example shows how the FCESTABL command is used. In this example, the FCESTABL
command establishes a relationship to copy the data from the source device, numbered 4202, to
the target device, numbered 4203. This relationship is established in NOCOPY mode after 4203
is offline.
94 Performing Compatible FlashCopy SE operations