Dvd-cd drive, Power supply, Dvd-cd drive power supply – HP 9000 Virtual Library System User Manual
Page 199
DVD-CD Drive
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless
all bays are populated with either a component or a blank.
1.
Power off the node.
NOTE:
The ejector button for the CD-ROM drive is recessed to prevent accidental ejection;
it may be helpful to use a small, flat, blunt object, such as a key or pen, to push the ejector
button.
2.
Press the ejector button in firmly until the DVD-CD drive ejects (1).
3.
Pull the DVD-CD drive out of the node (2).
To replace the component:
1.
Carefully align the connector on the rear of the drive with the connector on the DVD-CD drive
interface board.
2.
Slide the drive into the bay until it clicks.
Power Supply
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless
all bays are populated with either a component or a blank.
1.
Disconnect the power cord from the power supply.
VLS Node Component Replacement 199