HP 9000 Virtual Library System - Manual (Page 34)

Mounting Ethernet Switch 6600-24G into the Rack
1. At rack position 39, from the back of the rack align the grooved ends of the switch rails with
the posts on the mounting flanges. Placing the grooved ends between the mounting flange
and the loose washer and nut provides guidance.
2. Slide the switch fully into the rack.
3. Tighten the washer and nut on both sides of the rack to secure the switch rails to the mounting
flanges.
4. From the back of the rack, on each side of the switch, insert an M5 screw through the holes
in the rail and into the holes in the rack.
5. Tighten the M5 screws to secure the switch to the rack.
6. Attach a power cable to the switch's power supply.
7. Plug the power cable into an AC power source.
8. Route the power cable through the left side of the rack and plug it into a PDM.
9. Attach a 1U cover plate to the front of the rack.
10. Install the second Ethernet switch in rack position 40.
34 Hardware Installation