If your host computer system does not support mult, If another device id is placed between the jukebox, Press – HP Surestore 320ex Optical Jukebox User Manual
Page 52: If the jukebox is set to, (if using basic scsi addressing - lun mode off), Update, If the new settings do not conflict with other s, If the new settings conflict with other ids on t, Scsi ids:must be one digit apart, Scsi ids:when in lun mode
3-18
Chapter 3
Operating the Jukebox
Setting the SCSI IDs
If your host computer system does not support multiple types at the same ID and
you want to use LUN mode, you must select different IDs for the jukebox controller
(
JKBX ID #
) and the drives (
DRV #
). Tables in Appendix B show jukebox default
settings and an example of setting the jukebox controller and drives to different IDs
(one digit apart).
If another device ID is placed between the jukebox controller and the drives,
problems can result. For this reason, the jukebox will not accept IDs for the jukebox
controller and drives that are more than one digit apart. You will receive a
CONFLICT
message.
6. Press
NEXT
or
PREV
until the new ID that you want displays and then press
ENTER
.
If the jukebox is set to
LUN MODE ON
, go to Step 8. Only one ID can be
changed and the ID automatically updates when you press
ENTER
.
7. (If using basic SCSI addressing - LUN mode OFF) Press
NEXT
until
UPDATE
displays, and then press
ENTER
.
8.
UPDATE
or
WAIT FOR UPDATE
and then
ID’S SAVED
displays briefly.
•
If the new settings do not conflict with other SCSI IDs on the bus,
SCSI
ID’S
displays.
•
If the new settings conflict with other IDs on the SCSI bus,
CONFLICT-ABORTED
displays briefly and then
VIEW ID’S
displays.
Any changes entered are lost, and you must repeat steps 3 through 6 to set a
new ID.
NOTE
When in LUN mode:
If the new ID you choose results in the IDs for the jukebox controller and the drives
being more than one digit apart, the jukebox displays CONFLICT and rejects the
ID.
9. Press
CANCEL
until
READY
displays.
CAUTION
Turning off the jukebox in the next step could cause data loss if not done correctly.
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Check your host system manuals for information about checking the SCSI bus
status. If your computer is connected to a LAN, be sure to check with your system
administrator before turning off power to the jukebox.
10. Turn the jukebox OFF, then ON to save the IDs to the jukebox flash ROM.