HP XP P9500 Storage - Manual (Page 65)

oradb dev1 30095 02:40 0
oradb dev2 30095 02:41 0
•
Specifying “CU:LDEV” in hex used by SVP or Remote Web Console.
Example for LDEV# 260 01: 04
•
Specifying “LDEV” in decimal used by the RAID Manager inqraid command.
Example for LDEV# 260 260
•
Specifying “LDEV” in hex used by the RAID Manager inqraid command.
Example for LDEV# 260 0x104
HORCM_LDEV format can be used for XP1024/XP128 Disk Array and later. The LDEV# is converted
to “Port#, Targ#, Lun#” mapping to this LDEV internally, because the RAID storage system needs
to specify “Port#, Targ#, Lun#” for the target device. This feature is XP12000 Disk Array/XP10000
Disk Array and XP1024/XP128 Disk Array microcode dependent; if HORCM fails to start, use
HORCM_DEV.
(6) HORCM_LDEVG
The HORCM_LDEVG parameter defines the device group information that the RAID Manager
instance reads. For details about device group, refer to the manual HP P9000 RAID Manager User
Guide.
The following values are defined.
•
Copy group: specifies a name of copy group. This is equivalent to the dev_group of
HORCM_DEV and HORCM_LDEV parameters.
RAID Manager operates by using the information defined here.
•
ldev_group: Specifies a name of device group that the RAID Manager instance reads.
•
Serial#: Specifies a DKC serial number.
(7) HORCM_INSTP
This parameter is used to specify “pathID” for Continuous Access Synchronous link as well as
“HORCM_INST”.
HORCM_INSTP
dev_group ip_address service pathID
VG01 HSTA horcm 1
VG02 HSTA horcm 2
PathID can be specified for Continuous Access Synchronous. It cannot be specified for Cnt Ac-J.
PathID is used for the paircreate command and pairresync -swapp[s], so it must be specified at
the P-VOL and S-VOL sites. If PathID is not specified, it is used as CU free.
(8)HORCM_CTQM
This parameter is used to control Cnt Ac-J MxN configuration. For detail about Cnt Ac-J MxN
configuration, see the manual HP P9000 RAID Manager User Guide.
Examples of RAID Manager configurations
The followings show examples of RAID Manager configurations, the configuration definition file(s)
for each configuration, and examples of RAID Manager command use for each configuration.
Examples of RAID Manager configurations 65