HP XP Racks - Manual (Page 10)

Changing a community IP address
This topic describes the procedure to change a community IP address.
Prerequisite: You must have Storage Administrator (Initial Configuration) role to perform this task.
1.
From the Settings menu, select Environmental Setting - Edit Alert Settings.
2. In the Edit Alert Settings window, select the SNMP tab.
3. In the SNMP Trap Settings, select one or more specific IP addresses, and click SNMP Trap -
Change.
4. In the Change SNMP Trap window, select IPv4 or IPv6 for the version of the IP address and
enter the IP address for the SNMP Trap.
NOTE: Any IP address that has all values set to zero (0) cannot be specified for IPv4 and
IPv6. The IPv6 address is specified by entering eight hexadecimal numbers that are separated
by colons (:) using a maximum of 4 digits from zero (0) to FFFF inclusive. The default form of
the IPv6 address can be specified.
5. Enter a community name or select from the existing community names.
6. Click OK. The IP address you entered will be added to the IP Addresses in SNMP Trap Settings.
7. Click Finish.
8. In the Confirm window, enter a name for the task, confirm the settings, and click Apply.
For more information, see the HP XP7 Remote Web Console User Guide.
Deleting a Community IP address
This topic describes the procedure to delete a community IP address.
Prerequisite: You must have Storage Administrator (Initial Configuration) role to perform this task.
1.
From the Settings menu, select Environmental Setting - Edit Alert Settings.
2. In the Edit Alert Settings window, select the SNMP tab.
3. In the SNMP Trap Settings, select one or more specific Community and IP Address combinations,
and click SNMP Trap - Delete.
4. Click Finish.
5. In the Confirm window, enter a name for the task, confirm the settings, and click Apply.
For more information, see the HP XP7 Remote Web Console User Guide.
Managing community
Adding a community name
This topic describes how to add a community name.
Prerequisite: You must have Storage Administrator (Initial Configuration) role to perform this task.
1.
From the Settings menu, select Environmental Setting - Edit Alert Settings.
2. In the Edit Alert Settings window, select the SNMP tab.
3. In the SNMP Trap Settings, click Community - Add.
4. In the Add Community window, enter the desired community name in the Community field.
You can enter up to 180 alphanumeric characters. The following special characters are not
allowed: ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %.
5. Click OK.
6. To add one or more IP addresses to the new community, see “Adding a community IP address”
(page 9) .
7. Click Finish.
8. In the Confirm window, enter a name for the task, confirm the settings, and click Apply.
10 Using SNMP