HP LaserJet M5025 Multifunction Printer series - Manual (Page 71)

5. Touch TCP/IP .
6. Touch IPV4 Settings .
7. Touch Config Method .
8. Touch Manual .
9. Touch Save .
10. Touch Manual Settings .
11. Touch Default Gateway .
12. Touch the Default Gateway text box.
13. Use the touchscreen keyboard to type the default gateway.
14. Touch OK .
15. Touch Save .
Configure TCP/IPv6 parameters
For information about configuring the device for a TCP/IPv6 network, see the HP Jetdirect Embedded
Print Server Administrator's Guide.
Disable network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
● It decreases device-generated network traffic.
● It prevents unauthorized users from printing to the device.
● It provides only pertinent information on the configuration page.
● It allows the device control panel to display protocol-specific error and warning messages.
Disable IPX/SPX
NOTE Do not disable this protocol in Windows-based systems that print to the printer through
IPX/SPX.
1. Scroll to and touch Administration .
2. Scroll to and touch Initial Setup .
3. Touch Networking and I/O .
4. Touch Embedded Jetdirect .
5. Touch IPX/SPX .
6. Touch Enable .
ENWW Network configuration 59