HP XP RAID Manager Software - Manual (Page 13)

8. Click OK. The changed community name is displayed in the Community & Trap dialog box,
but the changes are not yet saved.
9. Click Apply to save the changes. A confirmation message is displayed.
10. In the confirmation message box, click OK to confirm the changes or Cancel to exit without
saving the changes.
Managing community IP addresses
Adding a community IP address
This section describes the procedure to add a community IP address:
Prerequisite: You must have the Storage Administrator (Initial Configuration) role to perform this
task.
1.
Launch Remote Web Console and log in.
2. In the Remote Web Console menu bar, click Settings> Environmental Setting > SNMP IP
Security. The SNMP IP Security window is displayed.
3. Click the Mode Changing icon ( ) to change to Modify mode.
4. In the SNMP IP Security window, click Extension SNMP (check box). The Community & Trap
dialog box is displayed.
5. In the Community & Trap dialog box, right-click the desired community. The Add Community
menu is displayed.
6. Select Add IP Address. The Add IP Address dialog box is displayed.
7. In the IP Address field, enter a new IP address or select an existing IP address.
•
If the values for an IP address are all set to zero (0), then that address cannot be specified
for IPv4 and IPv6.
•
The Add IP Address dialog box does not support shortened expression of the IPv6 address.
Enter 8 hexadecimal numbers that are separated by colons (:) to a maximum 4 digits
from zero (0) to FFFF inclusive.
NOTE: In SVP, Windows does not support IPv6. If the SVP OS is Windows XP and you enter
the IPv6 address and click Apply, an error message is displayed and the IPv6 address is not
set.
Managing community IP addresses 13