HP XP RAID Manager Software - Manual (Page 33)

A SNMP GUI reference
This appendix describes the procedures to use the SNMP IP Security window.
SNMP IP Security window
1. Launch Remote Web Console and log in.
2. In the Remote Web Console main window, click Settings> Environmental Setting> SNMP IP
Security in the menu bar. The SNMP IP Security window is displayed.
3. In the SNMP IP Security window, click SNMP IP Security. The following table describes the
items that are displayed.
Table 17 SNMP IP Security window
Description Item
The Extension SNMP checkbox is selected if the SNMP Agent feature is enabled. To set the
SNMP Agent properties from the Remote Web Console, select Extension SNMP in the SNMP
IP Security window. Install
The Manager section allows you to add and delete SNMP Manager information. Manager
Displays the IP addresses of registered SNMP managers from which the SNMP Agent accepts
requests. If no manager is registered, the SNMP Agent accepts requests from all managers.
You can register up to 32 managers. IP Address
Enter the IP address of the manager that the SNMP Agent receives the request from. IP Address
•
IPv4 and IPv6 addresses can be specified for IP Address. However, if the OS of the SVP
is Windows XP and you enter the IPv6 address and select Apply, an error message is
displayed and the IPv6 address is not set.
•
Any IP address having all values set to zero (0) cannot be specified for IPv4 and IPv6.
• The IPv4 address is specified by entering four numbers that are separated by periods (.)
using a maximum of three digits from zero (0) to 255 inclusive (for example,
XXX.XXX.XXX.XXX, where X is a number). Enter the numbers only; do not enter periods.
•
The IPv6 address is specified by entering eight hexadecimal numbers that are separated
by colons (:) using a maximum of 4 digits from zero (0) to FFFF inclusive. (For example:
SNMP IP Security window 33