Password masking – HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem User Manual
Page 6
Introduction 6
Non-VC modules are shown as “Unknown or unsupported module.” Detailed information is
displayed for supported VC modules only.
6.
Enter the update command to update the firmware on supported VC-Enet and VC-FC modules in the
enclosure. The update process takes approximately 20 minutes for each VC-Enet module, and 5
minutes for each VC-FC module to be updated.
The utility only updates supported VC modules that are able to be updated and require an update.
Password masking
For all of the commands provided by VCSU, the username, password, and IP address of the enclosure
OA must be provided. In some cases, the VC domain username and password must also be specified.
VCSU enables the user to enter the password interactively with password masking, primarily for security
reasons. To do this, enter the password as "*" and a prompt is provided that masks the input.
Example:
vcutil -a version -i 192.168.1.100 -u Administrator -p *
OA Password
:***********
Confirm Password :***********