HP ProLiant Support Pack - Manual (Page 36)

HP SUM User Interface 36
NOTE: In Linux, the Reboot Delay time is automatically converted from seconds to minutes.
Any value under a full minute, 59 seconds or less, will be rounded to the next minute for
Linux.
Make any changes, and click OK.
NOTE: The reboot options do not apply when deploying firmware for HP Integrity
BL860c/BL870c/BL890c i2 Servers. HP SUM reboots the server automatically during the
firmware update process when the user has selected Upload and Activate for the firmware.
Checking any other reboot options or setting a reboot delay is not applicable.
Component selection pane
The component selection pane of the Select Items to be Installed screen displays (by component number
order, unless a dependency causes the installation order to change) components available for installation
based on your server and hardware options. HP SUM verifies each component for dependencies, if the
component is already installed on the system, or if it requires a reboot after installation. Items available
for installation are selected by default. You can deselect any components you do not want to install.
The component selection pane is divided into the following columns:
• Product—Specifies the name of the component, version number, new component version number,
and the criticality status of the component updates. To view the component version history, click the
new version number. If a component is retrieved from ftp.hp.com, it has an HP icon next to it. For
Linux RPMs, the operating system and system architecture are listed.
Criticality Icon Text Description
Critical HP requires users to update to this component version immediately.
Recommende
d HP recommends that users update to this component version at their
earliest convenience.
Optional Update to this component version if their system is affected by one of
the documented fixes or if they want to utilize any of the enhanced
functionality provided by this version.
Unknown Component status is not available.
NOTE: All Linux RPMs have the Unknown criticality icon , because the RPM update
information is not available to HP SUM.
• Status—Displays the status of the component.
Icon Text Description
Ready for installation The component is ready for installation.
Not selected for
installation
The component has not been selected for installation.
Already up-to-date The component is already up-to-date. To downgrade or rewrite a
component, click Installation Options.
No device driver
installed
The firmware devices supported by the components in this section are
detected on the system but require a device driver. Install the device
driver.