HP ProLiant Support Pack - Manual (Page 70)

Scripted deployment 70
Command-line
argument Description
has been read in.
Component configuration for Windows components only
To configure components without using the HP Smart Update Manager GUI, issue the command,
hpsum_config <component_to_configure>. This command presents the same configuration screens
seen in the HP Smart Update Manager GUI. You must run this command from a CD or other read-only
media, or the component cannot be configured. Configuration for a given component only needs to be
executed once. The configuration is stored within the component and is propagated to all target servers
when deployed through HP Smart Update Manager GUI or command line. To change the configuration,
rerun hpsum_config against the component and a new configuration writes out. If a component does
not need configuration, the hpsum_config command returns to the console.
To configure components to be deployed on all editions of the Windows Server® 2008 with the Server
Core option, you must access the system as a remote host using HP Smart Update Manager running on a
system with a supported Windows® operating system, and then configure the components before
deployment.
Command-line examples
The following command-line parameter examples can be executed within these environments:
• Windows® PSPs:
o ProLiant Support Pack for Microsoft® Windows Server™ 2003 v7.90 (BP000323.xml)
o ProLiant Support Pack for Microsoft® Windows Server™ 2003 v7.80 (BP000315.xml)
• Firmware:
o System ROM
o Smart Array controller
o Hard drives
o iLO
• Software—later version of:
o HP Insight Diagnostics Online Edition for Windows Server™ 2003 (cp008097.exe)
o HP System Management Homepage for Windows® (cp008257.exe)
• HP Smart Update Manager
o Defined groups: Management Servers—Three servers (Management Server1, Management
Server2, Management Server3)
Example 1:
This command-line input deploys the latest PSP and firmware components:
hpsum /use_latest /allow_non_bundle_components /silent
Results: All software components from the 7.90 PSP and firmware components, which HP SUM
determined are required to be installed, were installed.
Example 2: