Odours, Take all food out of the appliance, Clean all packages – Siemens KI86SAD40 User Manual
Page 39: Switch the appliance on again, Store food in the appliance, Light (led), Tips for saving energy, If required, use an insulating plate, Select 560 mm cavity depth, Open the appliance as briefly as possible
 
en
39
Odours
If you experience unpleasant odours:
1. Switch off the appliance with the
On/Off button. Fig. 2/1
2. Take all food out of the appliance.
3. Clean interior (see chapter “Cleaning 
the appliance”).
4. Clean all packages.
5. Seal strong smelling food in order to 
avoid odours from forming.
6. Switch the appliance on again.
7. Store food in the appliance.
8. Check whether the formation of 
odours is still occuring after 24 hours.
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired by 
customer service or authorised 
technicians only.
Tips for saving energy
■
Install the appliance in a dry, well 
ventilated room! The appliance should 
not be installed in direct sunlight 
or near a heat source (e.g. radiator, 
cooker).
If required, use an insulating plate.
■
Select 560 mm cavity depth.
A smaller cavity depth will result in 
a higher energy consumption.
■
Allow warm food and drinks to cool 
down before placing in the appliance.
■
Thaw frozen food in the refrigerator 
compartment and use the low 
temperature of the frozen food to cool 
refrigerated food.
■
Open the appliance as briefly as 
possible.
■
Regularly defrost the freezer 
compartment to remove the layer 
of frost.
A layer of hoarfrost will impair 
refrigeration of the frozen food 
and increase power consumption.
■
Ensure that the freezer compartment 
door is always closed properly.
■
Occasionally clean the rear of the 
appliance to prevent an increased 
power consumption. 
■
The arrangement of the fittings does 
not affect the energy rating of the 
appliance.