Reset phone, Erase all contacts – Samsung SEC-R350WRAMTR User Manual
Page 102
99
Note: Emergency number 911 is hard-coded into your phone. You can dial
this number any time, even when the phone is locked or restricted. If
you call 911 an audible tone is heard and an Emergency prompt
appears in the display for the duration of the call.
Important!: Because of various transmission methods, network parameters,
and user settings used to complete a call from your wireless
phone, a connection cannot always be guaranteed. Therefore,
emergency calling may not be available on all wireless networks
at all times.
Important!: DO NOT depend on this phone as a primary method of calling
911 or for essential or emergency calls.
Remember to always turn your phone on and check for adequate
signal strength before placing a call.
Note: When you dial an emergency number, you phone locks itself to the
emergency location that answered the call and locks itself in 911-Only
mode, blocking from dialing any number but an emergency number.
Store Emergency Numbers
1.
From the Security menu, select Emergency #
.
2.
Select one of the three emergency numbers.
3.
Enter the emergency number (up to 32 digits in length).
4.
To save the number that you entered, press OK (
)
.
5.
To discard your entry and return to the previous menu,
p
ress
Cancel.
Call Emergency Numbers in Lock Mode
1.
In Standby mode, enter the emergency number using
either keypad.
2.
Press
to place the call.
Reset Phone
Reset Phone returns all setup parameters (except for the
Contacts entries) to their factory default values.
Caution!: Before selecting Reset Phone, contact your Wireless Provider.
Invoking Reset Phone may erase settings made by your Wireless
Provider from your phone, resulting in loss of service.
1.
From the Security menu, select Reset Phone. A prompt
appears in the display to restore default settings (except
for Contacts
).
2.
To reset your phone to factory default settings, press Yes.
To keep the current settings, press No.
Erase All Contacts
Erase All Contacts deletes all entries from the Contacts list.
1.
From the Security menu, select Erase All Contacts.
The “Erase all contacts?” prompt appears in the display
.