Samsung SCH-R560ZPACRI - Manual (Page 44)

41
Note: The Lookup command shows the requested contact information in the
display but does not dial any phone numbers for the contact.
To look up information for a specific contact:
1. In standby mode, press and hold to launch Voice
SVC.
“Say a Command” appears in the display and is
pronounced through the speaker.
2. Say “Lookup”.
Voice SVC prompts you to “Say the name.”
3. Speak clearly and say the full name of the person you want
to call, exactly as it is entered in your Contacts list.
• If VoiceSignal recognizes the name you said, the contact
information for that name appears in the display.
• If VoiceSignal does not recognize the name you said, a choice list of
up to three names appears in the display, and VoiceSignal prompts
you with “Did you say?” followed by the first name on the list.
4. Say “Yes” to confirm the name or “No” to hear the next
name, or use the keypad to select the correct name from
the list. (See “Choice Lists” on page 72, for more
information.)
• To say the name again, press the Repeat soft key.
• To exit VoiceSignal without dialing, press .
5. The contact information for the name you selected appears
in the display.
• To dial the number associated with the name, press .
• To erase this entry from your Contacts list, press the Erase soft key.
• To add or change information for this entry, press EDIT ( ).
• For more options, press the Options soft key and the following
options pop-up in the display:
– Send Txt Msg
– Send Pic Msg
– Send Video Msg
– Call
– Send Name Card Via Bluetooth
Quick Search Method
With Quick Search set to On, you can quickly access a Contact by
doing the following:
Note: For more information, refer to “Quick Search” on page 125.
1. In standby mode, press the first few numeric keys that
correspond to the letters of the contact’s name.