Application – Karcher SGV 8-5 User Manual
Page 10
– 2
– The appliance may only be
connected to an electrical
supply which has been in-
stalled by an electrician in ac-
cordance with IEC 60364.
– Never hold the mains plug
with damp hands.
– Make sure that the power
cord or extension cables are
not damaged by running
over, pinching, dragging or
similar. Protect the cable from
heat, oil, and sharp edges.
– The power cord must be
checked regularly for damag-
es, such as cracks or aging. If
damage is found, the cable
must be replaced before fur-
ther use.
– If couplings of the power cord
or extension cable are re-
place the splash protection
and the mechanical tightness
must be ensured.
– Do not clean the appliance
with a water hose or high-
pressure water jet (danger of
short circuits or other dam-
age).
– Unsuitable electrical exten-
sion cables can be hazard-
ous. Only use a splash-proof
electrical extension cable
with a minimum cross-section
of 3x1,5 mm
2
.
– The connection between
power cord and extension ca-
ble must not lie in water.
Notice
– Operating procedures create
short term power sinkings.
– During unfavorable net condi-
tions other devices might be
disturbed.
– With a net impedance lower
then 0,15 Ohm no disturbanc-
es are to be expected.
ƽ Danger
– Appliances with working
equipment, specifically the
power cord and the extension
cable, must be checked to en-
sure that it is in proper work-
ing order and is operating
safely prior to use. Otherwise,
immediately pull out the pow-
er plug. The appliance must
not be used.
– The water level limiter must
be cleaned regularly and
checked for signs of damage.
– Never spray and vacuum up
explosive liquids, combusti-
ble gases, explosive dusts as
well as undiluted acids and
solvents! This includes petrol,
paint thinner or heating oil
which can generate explosive
fumes or mixtures upon con-
tact with the suction air. Ace-
tone, undiluted acids and sol-
vents must also be avoided
as they can harm the materi-
als on the machine.
– Do not vacuum up any burn-
ing or glowing objects.
Application
10
EN