Sony PRS-900BC - Manual (Page 22)

22
Getting Started
Charging the Reader
About charging
You need to charge the Reader when using it for the
first time, or when the remaining battery power is low.
Charge in one of the following ways:
 Connect to an AC outlet using the supplied AC adapter (AC-
S5220E).
– It will take approximately 2.5 hours to fully charge the battery.
 Connect to a computer via USB ( page 42 ):
– It will take approximately 5 hours to fully charge the battery.
– While charging via USB, you cannot operate the Reader.
Notes
 The wireless feature is unavailable while the Reader is
connected via USB.
 When the remaining battery power is extremely low, if you
slide the POWER switch immediately after you connect the
Reader to an AC outlet, the Reader may not turn on and the
charge/busy indicator may blink. In this case, charge the
Reader for more than 5 minutes, then slide the POWER switch
to turn on the Reader.
Charging the Reader via an AC outlet
To charge the Reader via an AC outlet, follow the steps
below.

Connect the AC adapter to the DC IN jack of the
Reader.
AC adapter
(AC-S5220E)
Continued