APC AP7003 - Manual (Page 13)

9
Installing the Exhaust Kit
Installing into
ceiling plenum For this installation you will need the following:
• The ceiling adapter
• The holder flange
• The exhaust duct
• The base flange
Note: There should be about 12 to 15 inches of open space
above the ceiling adapter opening so that exhaust air is
not blocked
1. The exhaust duct is 8.5 feet long. Insert about 6 inches of
one end of the exhaust duct into the round hole in the ceil-
ing adapter.
2. Extend the 6 inches of the exhaust duct you have just
inserted and screw the holder flange as far as it will go onto
the exhaust duct.
3. Slide the ceiling tile out of the way about 10 to 12 inches.
4. Put the ceiling adapter into the ceiling tile grid.
Continued on next page