Drainage, Methods of draining, Condensate tank – APC AP7003 User Manual
Page 15: Methods of draining 11, Condensate tank 11
11
Drainage
Methods of
Draining
The NetworkAIR 1000 has two methods of disposing of the
condensation. The first is a condensate tank that can be
manually emptied. The second method is to attach a drain hose
to the unit so the water will run to a floor drain.
Condensate
Tank
The condensation will drain into the condensate tank when the
unit is in the Cooling or Dehumidifying mode. The Tank Full
indicator will flash on the control panel and the unit will beep
several times when the tank is full or has been removed from
the unit.
For safety reasons, the compressor stops at this time. The fan
will continue to operate at the same speed. However, if the tank
is not emptied or reinserted within three minutes, the fan will
stop.
Caution: Do not remove the tank when the unit is in use.
Always turn off the unit before removing the tank.
Periodically inspect and clean the drain valve to
prevent clogging.
Continued on next page